User's Manual

E12
2 PREPARATION
2-6 Setting on the Information Display
The table below shows the functions that can be set from the information display. For the detailed setting method, refer to
the “Display Operation Manual” at the end of this Operation Manual.
Functions that can be set from the information display
Reference page
in appendixes
Lens name Lens code setting E4
Initialize operation Initialize operation setting E4
Iris control
Iris gain
Setting the auto iris gain E4, E5
Setting the remote iris gain E5
Setting the iris correction to ON/OFF E5
Setting the iris close detection to ON/OFF E6
Zoom control
Setting the zoom servo start characteristics E6
Setting the zoom servo stop characteristics E6
Setting the zoom mechanism end stop characteristics E6
Preset
Setting the zoom servo start characteristics E7
Setting the zoom servo stop characteristics E7
Setting the analog demand curve characteristics E7
CAM mode settings E8
Setting the servo mode type from the zoom demand E8
Focus control Focus demand curve characteristics E9
Tally
Setting the tally lamp ON/OFF E6
Tally lamp light quantity setting E11
Indicator Setting the indicator ON/OFF E8
CAFS Setting the CAFS ON/OFF E9
IS
*
IS mechanical lock setting E10
IS operation switch setting E10
IS mode setting E10
Other
Encoder output setting E11
Setting the camera serial communication to ON/OFF E11
Adjusting the Camera Fol Voltage E12
Reset operation Reset to default values E1
*Only Models with IS Function