Technical information

3-21
SmartBase MPC600F/MPC400 Chapter 3: Assembly and Disassembly
Figure 3-19 Disassembly 12
Disassembly 12. Carriage unit
(1) Perform steps 1 and 2 of Disassembly 9.
(2) Disconnect the 3 cables found between the PCNT board (J1, J2, J3) and the carriage unit.
(3) By referring to the instructions on page 3-20, release the carriage lock.
(4) Remove the 2 screws (a), and detach the carriage guide frame.
(5) Remove the left/right shaft crip.
(6) Remove the carriage shaft.
(7) Remove the cable guide.
(8) Press the pulley to detach the carriage belt.
(9) Remove the tension spring and the carriage encorder film.
(10) Remove carriage unit.
Shaft clip
Shaft clip
Pulley
Carriage unit
Carriage shaft
Carriage encorder film
a
a
Cable guide
Carriage guide frame
Carriage belt
Tonsion spring