Technical information

3-16
SmartBase MPC600F/MPC400 Chapter 3: Assembly and Disassembly
Disassembly 8. Contact sensor drive motor
(1) Perform Disassembly 7.
(2) Remove the harness holder.
(3) Remove the 2 screws (a), and detach the grounding plate.
(4) Push the pulley toward the inside, and free the Contact sensor drive belt from the gear.
(5) Remove the screw (b), and detach the Contact sensor drive motor together with the plate.
(6) Remove the 2 screws (c), and detach the Contact sensor drive motor from the plate.
Figure 3-14 Disassembly 8
b
c
a
Contact sensor drive motor
Harness holder
Pulley
Grounding Plate
Contact sensor drive belt