Technical information

4-43
SmartBase MPC600F/MPC400 Chapter 4: Maintenance & Service
#1 SSSW (service soft switch setting)
SW26 (service soft switch 26: Transmission function setting)
Bit Function 1 0
0 Compulsory direct transmission Set Not set
1 Not used
2 Not used
3 (New) Prohibit broadcast Yes No
4 Not used
5 Not used
6 When STOP key is pressed Only cancel Cancel all
during a sequential broadcasting communication communication
7 Error transmission report when Not output Output
transmission is stopped
[Bit 3]
You may disable selection of multiple addresses to prevent broadcasting by mistake (on the part of
the user); however, this setting will not affect broadcasting by group dialing.
SW28 (service soft switch 28: V.8/V.34 protocol settings)
Bit Function 1 0
0 (New) Caller V.8 protocol NO YES
1 (New) Called party V.8 protocol NO YES
2 (New) Caller V.8 protocol late start NO YES
3 (New) Called party V.8 protocol late start NO YES
4 (New) V.34 reception fallback Prohibited Not prohibited
5 Not used
6 Not used
7 Not used
[Bit 0]
Select whether to use the V.8 protocol when calling. If NO is selected, the V.8 protocol is inhibited
at calling and the V.21 protocol is used.
[Bit 1]
Select whether to use the V.8 protocol when called. If NO is selected, the V8 protocol is inhibited
when called and the V.21 protocol is used.
[Bit 2]
If ANSam signal is not received during transmission (mainly manual transmission), select whether
to use the V.8 protocol when the other fax machine declares the V.8 protocol in DIS signal. If NO
is selected, the CI signal is not transmitted and the V.8 protocol is not used even if the DIS that
specifies the V.8 protocol is received.