Scanner User Manual
Table Of Contents
- ScanFront300/300P INSTRUCTIONS
- Introduction
- Table of Contents
- Chapter 1 Before Use
- Chapter 2 Handling
- Chapter 3 ScanFront Setup
- Chapter 4 ScanFront Service
- Chapter 5 Operating Procedures
- Chapter 6 Web Menu (Administrator Mode)
- Chapter 7 ScanFront Administration Tool
- Chapter 8 Web Menu (User Mode)
- Chapter 9 Maintenance
- Chapter 10 Troubleshooting
- Chapter 11 Appendices
3-12
Chapter 3 ScanFront Setup
❏ Display Language Setting
You can select the language displayed on touch panel. If
you change this setting, restart the scanner.
Hint
The display language setting can also be configured in
[Language/Timezone] on the Web Menu (Administrator Mode)
(see p. 6-30).
❏ Network Test
Confirm whether communication is enabled between the
ScanFront and other devices on the network. Enter the IP
address of a device and press the [Execute] button to ping
the specified IP address and confirm whether
communication with the device is enabled.