Wireless Setup Guide

11
The Camera Wireless Setup utility, as shown to
the right, will start up. Set the wireless settings in
this window.
7 Click [Next].
8 Select [Simple Mode] and click [Next].
We recommend you use the Simple Mode for
most purposes.
• We recommend you use the [Advanced Mode] if the following
conditions apply to your computer's wireless configuration.
• You are configuring an ad hoc network.
• You are performing the settings within a network with a system
administrator.
• The computer and wireless LAN router are connected by a cable.
• A fixed IP address is assigned. (IP address: an identifying number
assigned to a computer or other device on a network)
• Wireless LAN router is not equipped with a DHCP server function.
(DHCP server function: short for dynamic host configuration protocol
server function, which assigns dynamic IP addresses to devices in a
network)
• You can change the registered information in the camera if you place a
check mark beside [Change registered information in camera] and click
[Next].
If you are already using a wireless network, please proceed to Step 9 in the Wireless
Network Already In Use section (p. 12).
If you are using a 1:1 direct connection between the camera and computer, skip to
Step 9 in the 1:1 Direct Connection between Camera and Computer section (p. 14).
A
B