Technical information
Error
message
on
I
Try This
camera
Noink
Possible causes are
as
follows:
•
The
ink
has run out.
Replace the
FINE
Cartridge, and close the front cover.
If
lines are misaligned or the resulting output is not satisfactory, carry out the print head
alignment.
If
printing is in progress and you want to continue printing, press the
OK
button
on
the
printer.
Then
printing
can
continue under the
ink
out condition with the
FINE
Cartridge
installed. Replace the empty
FINE
Cartridge immediately after the printing.
The
resulting
print quality is not satisfactory,
if
printing is continued under the
ink
out condition.
• Some
FINE
Cartridges are not installed
in
place. Install the
FINE
Cartridges in the
appropriate positions.
•
The
FINE
Cartridge may not
be
the compatible with this printer. Install the appropriate
FINE
Cartridge.
If
lines are misaligned or the resulting output is not satisfactory, carry out the print
head alignment.
• This
FINE
Cartridge has previously been used.
• Ink may have
run
out.
The
function for detecting the remaining
ink
level
will
be
disabled since the remaining
ink
level cannot
be
correctly detected.
If
you want to continue printing
without
this function,
press the
OK
button.
Canon
recommends to use new genuine Canon cartridges in order to obtain optimum
qualities.
Printer error
An
error requiring servicing might have occurred. (Printer
POWER
lamp and Alarm lamp flash
alternately.)
Disconnect the cable between the printer and the camera.
Turn
off
the printer and unplug the
power cord
of
the printer from the power supply. After a while, plug the power cord
of
the
printer back in, turn
on
the printer, and then reconnect the camera to the printer.
If
the same problem occurs, contact the Customer
Care
Center.
Hardware Error
FINE
Cartridge errors have occurred. Replace the
FINE
Cartridge.
See
"Replacing a
FINE
Cartridge"
on
page 39.
*1
To
resume
printing,
you
can
press
the
OK
button
on
the printer instead of selecting
Continue.
*2
The
ink absorber absorbs ink
used
during cleaning, for
example.
Ifthis
message
appears,
you
will
need
to call for servicing to
replace
the absorber
and
to
check
the printer for proper
operation.
50