Technical information
Possible Cause I Try This
Inappropriate media
type is used
Paper thickness lever
position is not proper
• Check to see
if
the paper you are printing
on
is too thick.
See
"Print
Media to Avoid"
on
page
12.
• Note that smudging may occur at the top and bottom edges
of
the paper when using borderless
printing. Ensure that the paper you are using is compatible with borderless printing.
If
all four corners or the printing surface
of
the paper is curled, the paper may become
dirty
or not feed
properly through the printer.
Use
the paper after correcting paper curl
as
follows.
(1)
Place the paper
on
a flat surface with the print side
*1
face up, then cover
it
with plain regular paper
to avoid damaging the surface.
(2) Roll up the paper in the opposite direction
as
shown in the figure below.
(1)
(2)
*1
(3)
Check
the printing paper
if
paper curl
is
corrected within approximately 2 to 5 mmjO.08 to 0.2 inches*2.
It
is
recommended to print the curl-corrected paper
one
sheet at a time.
....................
~................
:
..
~~
..
Set the paper thickness lever to the left position.
If
the paper is scratched
even
when
printing
on
plain paper, set the paper thickness lever to the right
position.
Return the paper thickness lever to the left after printing.
47