Technical information

o Take out the Color FINE Cartridge (Cl-41) from its box and remove the protective
tape gently.
o Open the paper support and pull out the paper output tray.
Protective tape
Electrical contacts
Paper support
Paper output tray
W NOTE:
-Do not touch the electrical contacts or print head nozzles on a FINE Cartridge. The
printer may not print out properly if you touch it.
-Do not reattach the protective tape once you have removed it.
-Handle the removed protective tape carefully
to avoid getting your hands dirty or
staining surrounding
work area.
• Pinch the paper guide and slide it to the left. Load a few
sheets of blank paper into the auto sheet feeder, then slide
the paper guide toward the left edge of the paper.
Auto sheet feeder
• Insert the Color FINE Cartridge slightly slanted into the left slot (C).
Paper thickness lever
Print side
«) Push up the Color FINE Cartridge until it clicks into place.
A IMPORTANT: For correct printer operation, make sure the FINE Cartridge is secure in
slots.
e Repeat the procedure for the Photo FINE Cartridge (Cl-52), inserting it into the
right slot (P).
W NOTE: Ensure that the paper thickness lever is set to the left
position.
«) Ensure that the message requesting head alignment is
displayed on the lCD, select YES using the ~~ buttons ani
press the OK button.
The pattern is printed. And the print head is aligned
automatically.
A IMPORTANT: It takes about four minutes to finish printing.
When automatic print head alignment can not be
executed correctly, the message II HEAD ALIGNMENT
ERROR
II
is displayed on the LCD. refer to IIAn Error
Message is Displayed in the LCD
II
in the Direct Printing
Guide.
o Close the front cover first and the card slot cover next.
A IMPORTANT: Wait until the preparatory operation is complete; this takes about one
to two minutes.
The messa'ge requesting head alignment is displayed on the LCD.
Go to the next step.
Continue with Step 5
on side two_