User Guide

2. Removing the Transfer Charging Assembly
1) Remove the screw q, and remove the transfer charging assembly cover w; then,
remove the transfer charging assembly e by pulling it to the front.
Figure 4-324
3. Stringing the Primary/Transfer Charging Wire
a. Primary Charging Assembly
1) Remove the primary charging assembly.
2) Remove the four tension springs q (2 at front, 2 at rear), and remove the grid plate
w.
3) Remove the lid e (both front and rear).
Figure 4-325
4) Go to step 5) under b. “Transfer Charging Assembly.”
CHAPTER 4 IMAGE FORMATION SYSTEM
COPYRIGHT © 1997 CANON INC. CANON NP6330 REV.0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
4-37
w
q
e
q
w
e
q
e
Download Service Manual And Resetter Printer at http://printer1.blogspot.com