User Guide

6) Remove the two mounting screws !4, and remove the sensor mount !5.
7) Remove the sensor from the sensor mount.
Figure 5-813
7. Attaching the Side Guide Timing Belt for the Multifeeder Assembly
Butt the rack plate of the multifeeder against section A (open state).
Move the slide volume in the direction of B, and attach the timing belt to the pulley.
Figure 5-814
8. Installing the Feeding Roller of the Multifeeder
Install the pick-up roller q to the multifeeder pick-up assembly so that the belt pulley
w and the marking ‘1’ e are at the front of the copier.
q Pick-up roller
w Belt pulley
e Marking (roller)
Figure 5-815
q
w
e
5
5
(front)
Pulley
Pulley
Timing belt
Rack plate
Section A
Slide volume
B
!4
!5
COPYRIGHT © 1997 CANON INC. CANON NP6045 REV. 1 MAR. 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 5 PICK-UP/FEEDING SYSTEM
5-60