Service manual

2-2. Service Call Errors (by Cyclic Blinking in Orange (Alarm LED) and Green (COPY button), or
Alarm LED Lit in Orange)
Service call errors are indicated by the number of cycles the Alarm LED and COPY button blink, and the corresponding error
code is displayed on the LCD.
Cycles of blinking
in orange (Alarm
LED) and green
(COPY button)
Error
Error
code
Conditions
Solution
(Replacement of listed parts, which
are likely to be faulty)
2 times Carriage error [5100] An error occurred in the carriage encoder
signal.
- Carriage unit
- Timing slit film
- Logic board ass'y
- Carriage motor
3 times Line feed error [6000] An error occurred in the LF encoder signal. - Timing sensor unit
- Timing slit disk film
- Feed roller ass'y
- Platen unit
- Logic board ass'y
- Paper feed motor
4 times Purge cam
sensor error
[5C00] An error occurred in the purge unit. - Purge unit
- Logic board ass'y
5 times ASF (cam)
sensor error
[5700]
This error takes place when feeding paper from
the ASF after an error occurred in the ASF cam
sensor.
- Sheet feed unit
6 times Internal
temperature
error
[5400] The internal temperature is not proper. - Logic board ass'y
7 times Waste ink
absorber full
[5B00] The waste ink absorber is full.
- Ink absorber kit
8 times Print head
temperature
rise error
[5200] The print head temperature exceeded the
specified value.
- Print head
- Logic board ass'y
9 times EEPROM error [6800] A problem occurred in writing to the
EEPROM.
- Logic board ass'y
11 times Carriage lift
mechanism
error
[5110] The carriage did not move up or down
properly.
- PR lift shaft ass'y
- Sheet feed unit
- Logic board ass'y
- Carriage lift sensor unit
12 times AP position
error
[6A00] An error occurred in the AP motor during
purging operation.
- Sheet feed unit
- Logic board ass'y
- Purge unit
13 times Paper feed
position error
[6B00] An error occurred in the paper feed motor.
- Sheet feed unit
- Logic board ass'y
14 times Paper feed cam
sensor error
[6B10] An error occurred in the paper feed cam sensor
during paper feeding from the front paper feed
cassette.
This error is also indicated when the waste ink
counter is 60% or more, and a paper jam occurs
in the under guide.
- Sheet feed unit
- Logic board ass'y
15 times USB Host
VBUS
overcurrent
[9000] The USB Host VBUS is overloaded. - Logic board ass'y
16 times Valve sensor
error
[6C00] An error occurred in the valve sensor during
cleaning.
- Logic board ass'y
- Purge unit
17 times Motor driver
error
[6D00] The AD conversion value indicating the motor
driver temperature is not proper.
- Logic board ass'y
19 times Ink tank
position sensor
error
[6502] None of the ink tank position is detected.
- Platen unit
- Logic board ass'y
20 times Other hardware
error
[6500] The PCI bus error is detected by the ASIC. - Logic board ass'y
1-7