User`s guide

MP730/MP700
Software Guide
7
When you install the software, all the software you need is installed on your local hard disk drive. (Do not
install the software on the network drive.)
If you have version 4.4 or earlier of the MultiPASS Suite software installed on your computer, delete this
version before installing the new version.
When installing the software in Windows 2000/XP, you must log on as Administrator or have
Administrator privileges.
¡¡
¡¡
If there is a copy of the software on the local or network drive, you can install from the drive on which
the software is copied without having to use the MP730/700 Setup CD-ROM.
1 Turn on the printer. Do not connect the printer to the computer with the USB cable until instructed to
do so.
2 Turn on your computer.
If the printer is connected to your computer, the [New Hardware Found], [Device Driver Wizard],
[Add New Hardware Wizard] etc. screen appears. In this case, disconnect the USB cable, then click
[Cancel] on the screen.
3 Quit any applications (including virus checkers) that are currently running.
4 Insert the MP730/700 Setup CD-ROM into your disk drive.
The [MP Setup] screen is displayed.
Install the software by following in order steps 1, 2 and 3 as displayed in the [MP Setup] screen.
If this screen is not displayed, on the Windows desktop, double-click [My Computer] (Windows XP:
Click [Start], then click [My Computer]). Open the CD-ROM icon, then double-click
[setup(setup.exe)].
If you are installing from a copy saved on a network or hard disk, double-click [setup(setup.exe)] in
the copy.
1
Installing (Getting started)
Installing the software
[MP Setup] screen