User`s guide

MP730/MP700
Software Guide
14
When removing the software, first remove the MP Toolbox, and then the MP drivers.
Even if you are going to reinstall the software, you must still remove the currently installed software.
¡¡
¡¡
Windows 2000/XP: You must log on as Administrator or have Administrator privileges.
¡¡
¡¡
By following the steps below, all components of the MP drivers and MP Toolbox will be removed.
To remove the MP Toolbox
1 Quit the MP Toolbox etc., and any applications (including virus checkers) that are currently running.
To close the MP Toolbox, click on the [X] at the top right of the window.
2 On the Windows desktop, click [Start], point to [(All) Programs], [Canon], then [MP Toolbox 4.1]. Then
click [Uninstall Toolbox].
3 Follow the on-screen instructions.
When the Repair or Remove program selection screen is displayed, check [Remove], and then click
[Next].
If asked to confirm removal of an application etc., click [OK].
Restart your computer if a message asking you to do so appears.
To remove the MP drivers
1 Quit any applications (including virus checkers) that are currently running.
2 On the Windows desktop, click [Start], point to [(All) Programs], [Canon], then [MP drivers]. Then click
[Uninstall drivers].
3 In [Please select the device to delete], select the printer name ([MP730] or [MP700]), then click
[Perform].
The [Finish] screen is displayed.
4 Disconnect the USB cable from the computer and printer.
Windows 2000: The [Device removal warning] screen appears. Click [OK]. This will not affect the
printer or computer.
Restart your computer if a message asking you to do so appears.
To reinstall the software
After removing the MP Toolbox and MP drivers, reinstall the software. → “Installing the software”
1
Installing (Getting started)
Removing and Reinstalling the software