User`s guide

MP730/MP700
Software Guide
10
5 When the [Choose Destination Location] dialog box appears, click [Next].
6 Click [Next].
7 Click [Finish].
● Step 3 Connect the USB cable
1 Check that the printer is turned on.
2 Connect the USB cable to the printer and computer USB port.
When you connect the USB cable to the computer, the printer is automatically detected, and the
computer performs the various settings. Wait a while as your computer performs the various settings.
Depending on your computer, a message may display asking you to restart your computer. If this is
the case, restart your computer.
After restarting your computer, wait a while for your computer to continue performing the various
settings.
Install Utility Software
To install the Utility Software, in the [MP Setup] screen, click [Install Utility Software].
You can choose not to install the Utility Software at this stage and install it later.
View User’s Manual
To read the manual on the CD-ROM, click [View User’s Manual] on the [MP Setup] screen.
Installation is now complete. In the [MP Setup] screen, click [Exit] to close the screen. Then remove the
CD-ROM from the disk drive.
If installation fails before completion
Remove the software and reinstall it.
→ “Removing and Reinstalling the software”