Service manual

Chapter 5
5-9
##103 [RX] EOL cannot be detected for 5 sec (15 sec if CBT)
##104 [TX] RTN or PIN has been received
##106 [RX] The procedure singal cannot be received for 6 sec while in wait
##107 [RX] The transmitting machine cannot be use fallback
##109 [TX]
After transmitting DCS, a signal other than DIS, DTC, FTT, CFR, and
CRP was received, exceeding the permitted number of transmissions of
the procedure signal
##111 [TX/RX] Memory error
##114 [RX] RTN was transmitted
##200 [RX] During image reception, a carrier is not detected for 5 sec
##201 [TX/RX] DCN was received through a non-normal procedure
##204 [TX] Receive DTC without Tx data
##220 [TX/RX] System error (e.g., main program may have gone away)
##224 [TX/RX] Fault occurred in the communication procedure signal
##226 [TX/RX] Stack Pointer Not within RAM Range
##229 [RX] The recording system became locked for 1 min
##232 [TX] The unit used to control the encoder is faulty
##237 [RX] The IC used to control the decoder malfunctioned
##238 [RX] The unit used to control recording malfunctioned
##261 [TX/RX] System error occurred between the modem and system control board
##280 [TX]
The number of re-transmissions of the procedure signal has been
exceeded
##281 [TX]
The number of re-transmissions of the procedure signal has been
exceeded
##282 [TX]
The number of re-transmissions of the procedure signal has been
exceeded
##283 [TX]
The number of re-transmissions of the procedure signal has been
exceeded
##284 [TX] DCN has been received after transmission of TCF
##285 [TX] DCN has been received after transmitting EOP
##286 [TX] DCN has been received after transmitting EOM
No. Tx or Rx Definition