User`s guide

MP730/MP700
Software Guide (Scanning)
24
[Paper Size]
Select the size of the document to be scanned. When you select a size, the preview area size (height-
to-width ratio) will change.
For setting up the printer not to scan beyond the parameters of the scan when previewing or if you are
scanning without specifying the parameters of the scan. If you do not know the size of the document,
your setting should be on the large side. You can specify the parameters after previewing. If you
change the setting in [Paper size] after previewing, the preview image will be deleted.
[Multi-Crop]
Click [Apply] to crop individually two or more documents placed on the platen glass. Click [Scan] and
the documents will be scanned as separate documents.
To remove the cropping (specified parameters) around an image, right-click the image, then select
[Delete]. To remove all the cropping, click [Reset].
→ “[Multi-Crop] in ScanGear MP (Advanced Mode)”
[Selection]
You can specify the width and height of the parameters of the scan by entering a value. After entering
the value, either click on another area or press the Enter key and the size of the cropping frame will
change. Click (Keep proportions button) to change the icon to (Locked icon) and maintain the
width and height proportions of the image.
Some applications have a limit to the amount of image data they can receive. If the parameters of a
scan contain more than 21,000 × 30,000 pixels, the image will not scan.
The values you can enter will be within the parameters of the document size you have selected.
Minimum parameters of an image with [Output Resolution] set to [600] dpi are 96 × 96 pixels.
[Print Size]
For setting the print size (output size) of the scanning parameters you have specified.
Specify by entering a value in either [Width], [Height] or [Scale], or click a [Scale] value. After adjusting
the settings, either click on another area or press the Enter key, and the other values linked to the input
values will change. Even if you change these settings, the size of the cropping frame and the setting for
[Output Resolution] will not change. The resolution when you actually scan will change in accordance
with the percentage (%) entered in [Scale].
The ratio of [Width] and [Height] is linked to the [Width] and [Height] in [Selection]. You can make
settings for [Scale] between 25 and 400 in increments of 1%. [Scale] is fixed to 100% if 4800, 7200 or
9600 dpi is entered in [Output Resolution].