User`s guide

MP730/MP700

Software Guide (Scanning)

You scan specify the parameters of a scan by selecting a part of the image. When you scan again, only

the part of the image you have speciﬁed is scanned.

You can specify the parameters of a scan with one of the following methods.

To select the parameters of a scan automatically

After previewing, on the Toolbar, click (Auto crop button). Every time you click this button, the

parameters of the scan will gradually become smaller.

With the following operation, you can adjust the size and position of the speciﬁed area.

To specify the parameters of a scan

1 To maintain the current width and height proportions set for the image even after selecting the

parameters of the scan, on the Main tab, click (keep proportions) button.

2 Do one of the following.

¡¡

Specify by dragging

Click (Crop button). Then click and drag from the upper left corner of the parameter you wish to

specify to the lower right of the parameter. To adjust even further, drag the corner or border of the

selected parameters.

¡¡

Specify size

In [Width] and [Height], enter the parameters you want.

3 To move the crop border you have selected, place the mouse pointer inside the crop border, then

drag.

4 To preview the image, click [Preview].

To delete the settings, click on an area outside of the crop border.

Scanning documents

Setting preferences and scanning with ScanGear MP

Advanced Mode – Specifying the parameters of a scan