User`s guide

MP730/MP700
Software Guide (Scanning)
17
To specify in detail settings for scanning two or more photographs (small documents), use the [Multi-
Crop] in ScanGear MP (Advanced Mode).
Unlike the [Multi-Scan] in ScanGear (Simple Mode), you can set the scanning area etc.
1 Place the document face-down on the platen glass.
For placement of the documents, → “Scanning two or more small documents at one time.”
2 Do one of the following.
¡¡
¡¡
Use a button in the MP Toolbox
Click a button in the MP Toolbox, select [Use the scanner driver to make advanced settings], adjust
any other settings, then click [Scan].
¡¡
¡¡
Scan in an application
With Windows XP, if the system is set up for the WIA driver, switch to ScanGear MP (→ “Scanning
an image from an application”) and select the command for scanning a document in the application
(e.g. [Import], [Acquire image]. See your application documentation).
The ScanGear MP dialog box will open.
3 If the [Advanced Mode >>] is displayed, click [Advanced Mode >>].
4 Click [Preview].
The document will be provisionally scanned as a preview.
5 If necessary, change the settings in [Color Mode] or [Output Resolution].
→ “Advanced Mode — [Main] tab settings”
→ “Advanced Mode — [Settings] tab settings”
6 In [Multi-Crop], click [Apply].
Each of the preview photos is surrounded by dotted lines. Each of the documents is separated by its
frame of dotted lines and is scanned as a separate document.
To delete all the dotted lines, click [Reset].
7 If you wish to adjust the frame of dotted lines drag the dotted lines.
If you wish to delete the frame, right-click the frame and then click [Delete].
8 Click [Scan].
Scanning of the multiple documents will begin.
3
Scanning documents Scanning two or more small documents at one time
[Multi-Crop] in ScanGear MP (Advanced Mode)