Quick Start Guide

Load paper.

Place a stack of paper (print-side up) in the multi-purpose tray q.Pinch the paper

guide A and adjust to the width of the stack w.Then place the tray cover D over

the multi-purpose tray e.

NOTE

•You may have to move over the document cover cable E to place the tray cover on the

multi-purpose tray.

•Make sure the stack does not exceed the paper limit mark B or tab C.Otherwise a paper

jam may occur.

Install the printhead.

1 Press [Open] q and lift up the scanning unit w.

IMPORTANT

• Do not touch the metal rod or any parts inside the

machine.

• The machine must be turned on when opening the

scanning unit.

2 Remove the printhead from its packaging, then remove the orange protective

cap A.

IMPORTANT

•Do not touch the electrical contacts B.