User`s guide

00
ex. Print the following character data with 50 mm specified as the segment length, “Normal”
for the plate printing area, “Left” for character alignment, and 5 mm as the margin.
1
 Press[SegLen].
The segment length selection display appears.
When the specied segment length is shorter than 8.5 mm, the printer specications
change depending on the media type. Refer to “List of Function” ( page 151).
•
Confirmthat“Page”isselected.
2
 Press[
▲
]or[
▼
]toselect“Specify”,andtheninput“50”

(thesegmentlength).
If you accidentally input an incorrect number, press [Back Space] to delete the number
and then input the correct one.
To change the segment length of all pages after entering characters, press [
◄
] or [►]
to select “All”.
Some segment length cannot be specied depending on the character size.
segmentlengthrangethatcanbe
specified
3
 Press[Enter].
The Plate Printing Area selection display appears.•
4
 Press[
▲
]or[
▼
]toselect“Standard”,andthenpress[Enter].
The character alignment selection display appears.•
5
 Press[
▲
]or[
▼
]toselect“Left”,andtheninput“5”(the
margin).
If you accidentally input an incorrect number, press [Back Space] to delete the number
and then input the correct one.
If ”Normal” is selected on the Plate Printing Area selection display, you can specify
the left-justication margin between 2 mm and 5 mm.
If you select “Expansion,” you cannot specify the left-justication margin. It is xed at
0 mm.
If “Expansion” is selected on the Plate Printing Area selection display, only plates can
be used as the printing media.
Press[Enter].
The display returns to the character input display.•