User`s guide
91
Maintenance
Part 5
5
Remove the label tape if it is loaded.
If the label tape winds itself around some parts and therefore it
cannot be removed, proceed to step 6 without removing it.
6
Close the cover.
7
Pull out the printing media while pressing the
[
►
] key continuously to feed the tube reverse.
If you cannot pull out the printing media by
feeding the tube reverse, press the [
◄
] key to
feed the tube forward.
While you keep pressing the [
►
] or [
◄
] key,
the tube is continuously fed reverse or forward.
•
If the ribbon cassette could not be removed in step 4 or the label tape could not be removed in step 5, open
the cover and check whether the ribbon cassette or label tape can be removed.
If ribbon cassette or label tape can be removed, remove it and close the cover.
If ribbon cassette or label tape cannot be removed, close the cover and keep pressing the [
►
] or [
◄
] key
to check whether the ribbon cassette or label tape can be removed. Open/close the cover and keep pressing
the [
►
] or [
◄
] key repeatedly until the ribbon cassette or label tape can be removed.
8
Feed the tube reverse (by pressing the [
►
] key) or forward (by
pressing the [
◄
] key) repeatedly to pull out the printing media
completely.
9
Cut out the bent or damaged portion of the jammed printing
media or the printed portion of the printing media if it exists.
Thus, the printing media removal procedure is completed.•
10
Make preparations for printing (Part 2 “Basic Operations”).
Open the cover, load the removed ribbon cassette, tube, or label tape, and then close the
cover.
Press the [Cancel] key to return to the character input display.