User`s guide

73
Advanced Operations
Part 4
ex. Print the following character data with the segment length set to 50mm, “Left” set for the
character alignment, and a margin of 5mm.
1
Press [Length/Margin].
The Set length display appears.
2
Press [
] or [
] to select “2:Specify”, and then press Specify
[Enter].
The segment length input display appears.
Segment length can be set from 8 to 150 mm.
3
Enter “50” for the segment length, and press [Enter].
The character alignment selection display appears.
4
Press [
] or [
] to select “1:Left”, and then Press [Enter].
The margin setting input display appears.
The margin can be set from 2 to 5 mm only when left justi ed is selected.
5
Enter “5” for the margin, and press [Enter].
The display returns to the character input display.
6
Enter the character data and proceed to print.
The segment (cutting) length setting is restricted by the entered character data.
Set it within the range of the displayed message.