User`s guide
32
Number of characters that can be input
The printer can accept data input of totalling approximately 2500 characters on all pages
combined; if the printer’s capacity is exceeded, the message “Not enough memory
Character input is no longer possible.” appears. If this occurs, save all text data (
refer to
“Saving character data” on page 65), delete all characters that are displayed on the screen
(
refer to the Memo on the previous page, “Deleting all entered text”), and then continue
inputting new characters.
What is a page?
As used in relation to the printer, the term “page” has special meaning. The text entries
“200V”, “Pump Room” and “A1” that were input in the procedure described on page 30 are
actually input on three separate pages. A new page is created automatically whenever you
enter characters and press [Enter].
Viewing data from a previous page
If there is a page preceding the currently displayed page, “
◄
” appears in the upper left
corner of the screen. If you press the [
◄
] key and move the cursor to the left past the
fi rst character that is currently displayed on the screen, the screen will change to show the
character data from the preceding page. You can also jump directly to the preceding page
by pressing [Shift] + [
◄
].
If there is a page that following the currently displayed page, “
►
” appears in the upper right
corner of the screen. If you press the [
►
] key and move the cursor to the right past the
last character that is currently displayed on the screen, the screen will change to show the
character data from the next page. You can also jump directly to the next page by pressing
[Shift] + [
►
].
Indicates that there is a page
preceding the current page.
Indicates that there is a page
following the current page.