User`s guide

108
6.2
Message List
Message Description Action
Input value out of
range.
An attempt was made to input a value
that is outside of the settable range.
Make the correct setting according to the
pages 73 and 74.
Not enough memory.
Character input is no
longer possible.
An attempt was made to input characters
when there was insuf cient free space in
memory.
Delete some input data to free up some
space. See page 32.
Length exceeded.
Input data exceeds set
length.
Entered character length exceeded the
speci ed cut tube length.
Make the correct setting according to
page 72.
Not enough memory.
Cannot save any more
les.
An attempt was made to save a le
while there was insuf cient free space
remaining.
Delete any unnecessary les to create
free space. See page 67.
Already 20 les! An attempt was made to save more than
20 les.
Either delete any unnecessary les and
then save the desired les.
No les. An attempt was made to load or delete
a le even though no les have been
saved.
Save the le once more. See page 65.
No media. An attempt was made to print while no
printing media has been loaded.
Load the print media and then press
[Enter] to begin printing. See page 24.
No Ribbon cassette. An attempt was made to print while no
ribbon cassette was installed.
Install a ribbon cassette. See page 24.
End of media. Pull out
print media.
The end of the printing media was
reached while printing was in progress.
Take out the printing media from the
printer, and replace it with new printing
media. Set the media according to pages
28 and 35, and then press [Enter] to start
printing.
End of ribbon
Replace ribbon
cassette.
The end of the ribbon cassette was
reached while printing was in progress.
Install a new ribbon cassette, and then
press [Enter] to resume printing.
See page 100.
Cannot initialize print
head position.
It is impossible to initialize the print head
position for some reason.
Press [Enter]. If the same message
appears again, contact your dealer.
Cannot move print
head to print position.
It is impossible to move the print head to
the printing position for some reason.
Press [Enter]. If the same message
appears again, contact your dealer.
Cannot initialize cut
position.
It is impossible to initialize the cutter
position for some reason.
Press [Enter]. If the same message
appears again, contact your dealer.
Close cover and press
any key.
An operation was attempted while the
cover was open.
Close the cover and press any key.
See pages 27 and 35.
Memory backup
battery low. Contact
dealer.
The memory backup batteries do not
have adequate capacity.
Contact your dealer.
Memory backup
battery exhausted.
Resetting memory.
Because the memory backup batteries
do not have adequate capacity, the data
settings have been initialized.
Contact your dealer.
Media JAM
Enter/Cancel
Tube or label tape is jammed. Refer to “If a Tube or Label Tape
Becomes Jammed” and remove the
jammed object.
Printing...
Ribbon will end soon
Remaining ribbon is low when printing.
(approximately 10m remaining)
Have a new ribbon cassette ready.
Replace with new ribbon cassette if
printing a long document. See page 100.
No ribbon information.
No ribbon amount
displayed. Press enter
The printer could not properly
communicate with the ribbon cassette.
Follow the instruction on the screen.