User`s guide

97
Maintenance
Part 5
4
Press [
◄
] or [
►
] to select “4:Label”, and then press [Enter].
The Full-cut adjustment display appears.
The cutting depth can be set for each type of printing media.
•
5
Press [
▲
] once, so that “Deep 1” appears.
Each time [
▲
] is pressed, the cutting depth increases by one.•
6
Press [Enter].
The display returns to the character input display. The cutting
depth is now one step deeper.
•
What to do if the cutter still does not cut well (Force full cut)
If the cutter will not cut well no matter how much you adjust the cutting depth, try using
“Force full cut”. When force full cut is performed, the cutter cuts to the deepest depth
possible. If the cutter still does not cut even when using force full cut, the cutter needs to
be replaced. For details on the replacement procedure, refer to “Replacing the cutter” (
page 98).
1.
Press [Option]. Option
The setting display appears.•
2.
Press [
◄
] or [
►
] to select “3:Maintenance”,
Maintenance mode and press [Enter].
The Maintenance selection display appears.•
3.
Press [
◄
] or [
►
] to select “2:Full-cut”, and
then press [Enter].
The full cut confirmation display appears.•
4.
Press [Enter].
A full cut is made.•