LV-7575 Expand Serial Command Functional Specifications

LV-7575 Expand Serial Command Functional Specifications
24/71
8.5.5 CF_V-POS Command
Command “CF_V-POS_%1” [CR]
%1
“0000-nnnn” ------------ Directly specify setting value of Vertical Position
“nnnn” indicates maximum value, which is current (Total Line – Display Area V) value
“UP” --------------------- Increment setting value of Vertical Position by 1
“DN” --------------------- Decrement setting value of Vertical Position by 1
Details
Set Vertical Position value (Available only in the normal Power ON status)
The value set by this command will not be stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Standby mode.)
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- When input is Video signal
8.5.6 CF_DDOTS Command
Command “CF_DDOTS_%1” [CR]
%1
“0100-nnnn” -------------- Directly specify setting value of Display Dots
“nnnn” indicates maximum value, which is current value of (Total Dots - Position
H).
In this projector, the value should be “even number” and if “odd number” is specified, it
adds 1 to make the value even number.
“UP” ------------------------ Increment setting value of Display Dots by 2
“DN” ------------------------ Decrement setting value of Display Dots by 2
Details
Set setting value of Display Dots in PC signal (Available only in the normal
Power ON status)
The value set by this command will not be stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Standby mode.)
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] --- When input is Video signal
8.5.7 CF_DLINE Command
Command “CF_DLINE_%1” [CR]
%1
“0100-nnnn” ----------- Directly specify setting value of Display Line
“nnnn” indicates maximum value, which is current value of (Total Line - Position V).
“UP” ------------------- Increment setting value of Display Line by 1
“DN” ------------------- Decrement setting value of Display line by 1
Details
Set setting value of Display Line in PC signal (Available only in the normal Power
ON status)
The value set by this command will not be stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Standby mode.)
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] --- When input is Video signal