Manualshelf

LV-7575 Expand Serial Command Functional Specifications

ManualsBrandsCanon ManualsProjectorLV-7575
21222324252627282930
LV-7575 Expand Serial Command Functional Specifications
23/71
8.5.2 CF_TDOTS Command
Command “CF_TDOTS_%1” [CR]
%1
“mmmm - nnnn” --------------- Directly specify setting value of Total Dots
“mmmm” indicates minimum value, which is current (Display area H + Position H)
value
“nnnn” indicates maximum value, whichi is less than 140 MHz in Dot Clocks
“UP” ------------------------- Increment setting value of Total Dots by 1
“DN” ------------------------- Decrement setting value of Total Dots by 1
Details
Set value of Total Dots in PC signal (Available only in the normal Power ON
status)
The value set by this command will not be stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Standby mode.)
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] --- When input is Video signal
8.5.3 CF_CLPPHASE Command
Command “CF_CLPPHASE_%1” [CR]
%1
“0001-0225” ----------- Directly specify setting value of Clamp Phase
“UP” --------------------- Increment setting value of Clamp Phase by 1
“DN” --------------------- Decrement setting value of Clamp Phase by 1
Details
Set value of Clamp Phase (Available only in the normal Power ON status)
The value set by this command will not be stored in the projector. Therefore, when
the power is turned to ALL OFF, the value returns to the original setting. (It is
stored in Standby mode.)
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.5.4 CF_H-POS Command
Command “CF_H-POS_%1” [CR]
%1
“0000-nnnn” -------- Directly specify setting value of Horizontal Position
“nnnn” indicates maximum value, which is current value of (Total dots - Display area H)
“UP” ------------------- Increment setting value of Horizontal Position by 1
“DN” ------------------ Decrement setting value of Horizontal Position by 1
Details
Set value of Horizontal Position in PC signal (Available only in the normal Power
ON status)
The value set by this command will not be stored in the projector’s memory.
Therefore, when the power is turned to ALL OFF status, the value returns to the
original setting. (It is stored in Standby mode.)
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] --- When input is Video signal