LV7565_Basic_Command_Specification

Basic Serial Command Specification Page 11 of 20
6.28. IMAGE Command
Command “C27” [CR]
Detail
Change Image setting status.
Works for “IMAGE” function when there is “IMAGE” function with the
Projector or the Remote Control unit.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.29. ON START SETTING Command
Command “C28” [CR]
Detail
Set to Power ON Start setting status
This setting status is stored in EEPROM, even if the power is ON / OFF.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.30. ON START CANCELATION Command
Command “C29” [CR]
Detail
Cancel Power ON Start
This status is stored in EEPROM even when power is ON / OFF.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.31. POWER MANAGEMENT SETTING Command
Command “C2A” [CR]
Detail
Set Power Management.
This status is stored in EEPROM even when power is ON / OFF.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.32. POWER MANAGEMENT CANCELATION Command
Command “C2B” [CR]
Detail
Cancel Power Management Setting.
This status is stored in EEPROM even when power is ON / OFF.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]
6.33. D.ZOOM + Command
Command “C30” [CR]
Detail
Digital Zoom Mode: Zoom in
This command works same as the Remote Control “D.ZOOM Up” button.
Acceptable [ACK] [CR]
Response
Unacceptable “?” [CR]