Expanded_Serial_Command_Codes

Expand Serial Command Functional Specification Page 40 of 41
9.11.14. CR_AUTOSETUP Command
Command “CR_AUTOSETUP_%1” [CR]
%1
“KEYSTONE” --------- Specify Auto Keystone
“PCADJ” ---------------- Specify Auto PC Adj.
Details Get Auto Setup setting status
Acceptable “000_%a” [CR]
%a
When Keystone
“AUTO” ----------- Auto setting
“MANUAL” ------ Manual setting
”OFF” ------------- Off setting
When Auto PC Adj.
“ON” ------------ On setting
“OFF” ----------- Off setting
Response
Unacceptable “?” [CR]
9.11.15. CR_FANMODE Command
Command “CR_FANMODE” [CR]
Details Get selected Fan mode.
Acceptable “000_%a” [CR]
%a
“L1” -------- Fan mode L1
“L2” -------- Fan mode L2
Response
Unacceptable “?” [CR]
9.12. Other Status Read Command
9.12.1. CR_SIGNAL Command
Command “CR_SIGNAL” [CR]
Details Get information if there is signal or not.
Acceptable “000_%a” [CR]
%a
“ON” ------- There is signal
“OFF” ------ No signal
Response
Unacceptable “?” [CR]
9.12.2. CR_VMUTE Command
Command “CR_VMUTE” [CR]
Details Get No Show setting status.
Acceptable “000_%a” [CR]
%a
“ON” -------- Set No Show
“OFF” ------- Cancel No Show
Response
Unacceptable “?” [CR]
9.12.3. CR_FREEZE Command
Command “CR_FREEZE” [CR]
Details Get Freeze setting status.
Acceptable “000_%a” [CR]
%a
“ON” --------- Set Freeze
“OFF” -------- Cancel Freeze
Response
Unacceptable “?” [CR]