Expanded_Serial_Command_Codes

Expand Serial Command Functional Specification Page 32 of 41
9.5.6. CR_DDOTS Command
Command “CR_DDOTS” [CR]
Details Get Display Dots value
Acceptable “000_%a” [CR]
%a
“0100” – “nnnn”
(nnnn = Total Dots – Horizontal Position)
Response
Unacceptable
“Error code” [CR] ---- Invalid
“?” [CR] ---------- When the Projector received unclear command
9.5.7. CR_DLINE Command
Command “CR_DLINE” [CR]
Details Get Display Line value
Acceptable “000_%a” [CR]
%a
“0100” – “nnnn”
(nnnn = Total Line – Vertical Position)
Response
Unacceptable
“Error code” [CR] ---- Invalid
“?” [CR] ---------- When the Projector received unclear command
9.5.8. CR_PCSTORE Command
Command “CR_PCSTORE” [CR]
Details
Get the status if Mode1–Mode5 is Free or Stored for PC Adjust.
Each data Mode1–Mode5 will be shown in 5 bytes.
(F: Free, S: Stored)
Acceptable “000_%a” [CR]
%a
“FFFFF” --------- All Free
“SFFFF” --------- Only Mode1 is Stored, and others are Free
:
“FFFFS” --------- Only Mode5 is Stored, and others are Free
“SSSSS” ---------- All Stored
Response
Unacceptable “?” [CR]
9.5.9. CR_SETPCADJ Command
Command “CR_SETPCADJ” [CR]
Details Get PC signal for current system.
Acceptable “000_%a” [CR]
%a
“XGA1”
“HDTV1080”
“MODE1” – “MODE5” … Etc.
Response
Unacceptable “?” [CR]