Expanded_Serial_Command_Codes

Expand Serial Command Functional Specification Page 26 of 41
8.11.14. CF_STANDBYMODE Command
Command “CF_STANDBYMODE_%1” [CR]
%1
“ECO” ------------ Standby power requirement is smaller
“NORMAL” ----- Normal Standby power requirement
Details Set Standby mode. (Only valid when it is in the usual Power On status)
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.11.15. CF_POINTER Command
Command “CF_POINTER_%1_%2” [CR]
%1
“SPOTLIGHT” --------- Select Spotlight
“ARROW” --------------- Select Arrow
“FINGER” -------------- Select Finger
“LASER” ----------------- Select Laser mark
%2
“MAX” ---------- Maximum Spotlight
“MID” ---------- Medium Spotlight
“MIN” ---------- Minimum Spotlight
Details
Select Pointer image. (Only valid when it is in the usual Power On status)
Note1) %2 is available when “SPOTLIGHT” is specified only.
When ”ARROW” / ”FINGER” / ”LASER”, specify ”CF_POINTER_%1” [CR]
Note2) When “SPOTLIGHT”, %2 cannot be omitted.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.11.16. CF_FDEFAULT Command
Command “CF_FDEFAULT_%1” [CR]
%1 “RST”
Details Set Factory Default. (Only valid when it is in the usual Power On status)
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.11.17. CF_AUTOSETUP Command
Command “CF_AUTOSETUP_%1_%2” [CR]
%1 %2
“KEYSTONE”
“AUTO” ----------- Auto setting for Auto Keystone
“MANUAL” ----- Manual setting for Auto Keystone
“OFF” ------------- Off for Auto Keystone
“PCADJ”
“ON” --------------- On for Auto PC Adj.
“OFF” ------------- Off for Auto PC Adj.
%
“START” None
Details
Select Auto Setup function. (Only valid when it is in the usual Power On status)
Note1) When started Auto Setup, can not doing CF Command during end of Auto
Setup. In this bout, return error code “302” if send out command.
Note2) Can not “OFF” the both KEYSTONE and PCADJ.
When KEYSTONE or PCADJ is “OFF”, return error code “101” if set
Keystone or PCADJ.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]