Expanded_Serial_Command_Codes

Expand Serial Command Functional Specification Page 19 of 41
8.7.2. CF_SOURCE Command
Command “CF_SOURCE_%1” [CR]
Computer 1
“DIGITAL” --------- Select Digital Input
“ANALOG” -------- Select Analog Input
“HDCP” ------------- Select DVI HDCP Input
Computer 2
“ANALOG” --------- Select RGB Input
“YPBPR” ------------- Select Component Input
“SCART” ------------- Select SCART RGB Input
%1
Video
“AUTO” -------------- Select Vide Auto mode
“VIDEO” ------------- Select Composite Video Input
“S-VIDEO” ---------- Select S-Video Input
Details
Select current input source.
(Only valid when it is in the usual Power On status)
When selected Input and specified %1 are not matched, the Projector returns
“101” and does not execute the command.
Note) When the optional MCI Box is installed to COMPUTER-1, selection for
source is invalid. Error Code is “101”.
Acceptable “000” [CR]
Response
Unacceptable “%%%” [CR]
8.7.3. CF_INPUT_%1_%2 Command
Command “CF_INPUT_%1_%2” [CR]
%1
“COMPUTER1” ----------- Select Computer 1 Input
“COMPUTER2” ----------- Select Computer 2 Input
“VIDEO” ------------------- Select Video Input
%2
When %1 is COMPUTER1
“ANALOG” ------------- Select Analog RGB Input
“DIGITAL” ------------- Select Digital Input
“HDCP” ----------------- Select DVI HDCP Input
When %1 is COMPUTER2
“ANALOG” ------------- Select RGB Input
“YPBPR” --------------- Select Component Input
“SCART” --------------- Select SCART RGB Input
When %1 is VIDEO
“AUTO” ----------------- Select Video Auto mode
“VIDEO” ---------------- Select Video
“S-VIDEO” ------------- Select S-Video
Details
Select Input and also the source that is specified in %2.
(Only valid when it is in the usual Power On status)
Acceptable “000” [CR]
Response
Unacceptable “%%%” [CR]