Expanded_Serial_Command_Codes

Expand Serial Command Functional Specification Page 18 of 41
8.6.3. CF_AVHPOS Command
Command “CF_AVHPOS_%1” [CR]
%1
“UP” ------------ Current setting value +1
“DN” ------------ Current setting value –1
Details
Set AV Service Mode Horizontal Position value.
(Only valid when it is in the usual Power On status)
This setting status is stored in EEPROM, hold even if AC Power turning Off and
On. When there e is no signal, the Projector returns “101” [CR].
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- Input is PC
8.6.4. CF_AVVPOS Command
Command “CF_AVVPOS_%1” [CR]
%1
“UP” ------------ Current setting value +1
“DN” ------------ Current setting value –1
Details
Set AV Service Mode Vertical Position value.
(Only valid when it is in the usual Power On status)
This setting status is stored in EEPROM, hold even if AC Power turning Off and
On. When there e is no signal, the Projector returns “101” [CR].
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- Input is PC
8.6.5. CF_AVSERV Command
Command “CF_AVSERV_%1” [CR]
%1 “RST”
Details
Set AV Horizontal / Vertical resolution that is set in such as “CF_AＶDDOTS”
/ ”CF_AＶＤＬＩＮＥ” to default setting value.
(Only valid when it is in the usual Power On status)
This setting status is stored in EEPROM, hold even if AC Power turning Off and
On. When there e is no signal, the Projector returns “101” [CR].
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- Input is PC
8.7. Input Control Command
8.7.1. CF_INPUT Command
Command “CF_INPUT_%1” [CR]
%1
“COMPUTER1” --------- Select Computer 1 Input
“COMPUTER2” --------- Select Computer 2 Input
“VIDEO” ------------------- Select Video Input
Details
Select Input. (Only valid when it is in the usual Power On status)
The Command works as the same as the Projector or Remote Control unit
“INPUT” button.
Note1) If trying to select COMPUTER-2 terminal when setting Computer-2 to
Monitor Out, the Projector returns “101”.
Note2) When option box is installed, the selection of Computer-1 is Memory Card
/ Wireless / Network.
Acceptable “000” [CR]
Response
Unacceptable “%%%” [CR]