Expanded_Serial_Command_Codes

Expand Serial Command Functional Specification Page 17 of 41
8.5.8. CF_PCSTORE Command
Command “CF_PCSTORE”_%1” [CR]
%1
“MODE1” ------------ Store current PC Adjust status to Mode 1
“MODE2” ------------ Store current PC Adjust status to Mode 2
“MODE3” ------------ Store current PC Adjust status to Mode 3
“MODE4” ------------ Store current PC Adjust status to Mode 4
“MODE5” ------------ Store current PC Adjust status to Mode 5
Details
Store current PC Adjust status (each parameter status such as Total dots) to
Mode 1 – 5.
This command operates the same operation as storing to Mode1 – Mode5 in PC
Adjust Menu.
(Only valid when it is in the usual Power On status)
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- Input is Video
8.5.9. CF_PCMODEFREE Command
Command “CF_PCMODEFREE_%1” [CR]
%1
“MODE1” -------- Mode 1 to Free
“MODE2” -------- Mode 2 to Free
“MODE3” -------- Mode 3 to Free
“MODE4” -------- Mode 4 to Free
“MODE5” -------- Mode 5 to Free
Details
Reset Mode 1, 2, 3, 4, and 5 to Free.
This command works as the same when resetting Modes in PC adjust menu.
(Only valid when it is in the usual Power On status)
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- Input is Video
8.6. Video Control Command
8.6.1. CF_AVDDOTS Command
Command “CF_AVDDOTS_%1” [CR]
%1
“UP” ------------ Current setting value +1
“DN” ------------ Current setting value –1
Details
Set AV Service Mode Horizontal Resolution value.
(Only valid when it is in the usual Power On status)
This setting status is stored in EEPROM, hold even if AC Power turning Off and
On. When there e is no signal, the Projector returns “101” [CR].
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- Input is PC
8.6.2. CF_AVDLINE Command
Command “CF_AVDLINE_%1” [CR]
%1
“UP” ------------ Current setting value +1
“DN” ------------ Current setting value –1
Details
Set AV Service Mode Vertical Resolution value.
(Only valid when it is in the usual Power On status)
This setting status is stored in EEPROM, hold even if AC Power turning Off and
On. When there e is no signal, the Projector returns “101” [CR].
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- Input is PC