Expanded_Serial_Command_Codes

Expand Serial Command Functional Specification Page 16 of 41
8.5.5. CF_V-POS Command
Command “CF_V-POS_%1” [CR]
%1
“0000 – nnnn” ----------- Directly set Vertical Position setting value
“nnnn” is maximum value. This is current Total Line
value - Display Line value.
“UP” ---------------------- Vertical Position setting value +1
“DN” -------------------- Vertical Position setting value –1
Details
Set Vertical Position PC signal.
(When it is in usual Power On state, this is valid)
The value set by the command will not be saved to the Projector.
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- Input is Video
8.5.6. CF_DDOTS Command
Command “CF_DDOTS_%1” [CR]
%1
“0100 – nnnn” --------- Directly set Display Dots setting value
“nnnn” is maximum value. This is current Total Dots value
– Horizontal Position value.
“UP” ---------------------- Display Dots setting value +1
“DN” ---------------------- Display Dots setting value –1
Details
Set Display Dots PC signal.
(When it is in usual Power On state, this is valid)
The value set by the command will not be saved to the Projector.
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- Input is Video
8.5.7. CF_DLINE Command
Command “CF_DLINE_%1” [CR]
%1
“0100 – nnnn” --------- Directly set Display Line setting value
“nnnn” is maximum value. This is current Total Line value
– Vertical Position value.
“UP” ---------------------- Display Line setting value +1
“DN” ---------------------- Display Line setting value –1
Details
Set Display Line PC signal.
(When it is in usual Power On state, this is valid)
The value set by the command will not be saved to the Projector.
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- Input is Video