Expanded_Serial_Command_Codes

Expand Serial Command Functional Specification Page 15 of 41
8.5. PC Control Command
8.5.1. CF_FSYNC Command
Command “CF_FSYNC_%1” [CR]
%1
“0000 – 0031” --------- Directly set Fine Sync setting value
“UP” --------------------- Fine Sync setting value +1
“DN” --------------------- Fine Sync setting value -1
Details
Set Fine Sync for PC signal. (When it is in usual Power On state, this is valid)
The value set by the command will not be saved to the Projector.
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- Input is Video
8.5.2. CF_TDOTS Command
Command “CF_TDOTS_%1” [CR]
%1
“nnnn – 9999” -------- Directly set Total Dots setting value
“nnnn” is minimum value. This is current Display Dots
value＋Horizontal position value
“UP” --------------------- Total Dots setting value +1
“DN” --------------------- Total Dots setting value –1
Details
Set Total Dots for PC signal. (When it is in usual Power On state, this is valid)
The value set by the command will not be saved to the Projector.
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- Input is Video
8.5.3. CF_CLAMP Command
Command “CF_CLAMP_%1” [CR]
%1
“0000 – 0127” --------- Directly set Clamp setting value
“UP” --------------------- Clamp setting value +1
“DN” --------------------- Clamp setting value –1
Details
Set Clamp PC signal. (When it is in usual Power On state, this is valid)
The value set by the command will not be saved to the Projector.
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- Input is Video
8.5.4. CF_H-POS Command
Command “CF_H-POS_%1” [CR]
%1
“0000 – nnnn” ------------ Directly set Horizontal Position setting value
“nnnn” is maximum value. This is current Total Dots
value - Display Dots value.
“UP”
------------------------- Horizontal Position setting value +1
“DN” ------------------------- Horizontal Position setting value –1
Details
Set Horizontal Position PC signal.
(When it is in usual Power On state, this is valid)
The value set by the command will not be saved to the Projector.
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Acceptable “000” [CR]
Response
Unacceptable “101” [CR] ---- Input is Video