Expanded_Serial_Command_Codes

Expand Serial Command Functional Specification Page 14 of 41
8.4.9 CF_PROGV Command
Command “CF_PROGV_%1” [CR]
%1
“L1” ------------- Select Progressive Mode L1
“L2” ------------- Select Progressive Mode L2
“OFF” ---------- Cancel Progressive
Details
Set / Cancel for Progressive.
The value set by the command will not be saved to the Projector.
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.10. CF_FILM Command
Command “CF_FILM_%1” [CR]
%1
“ON” --------------- Film Mode ON
“OFF”
-------------- Film Mode OFF
Details
Set / Cancel for Film Mode.
The value set by the command will not be saved to the Projector.
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.11. CF_IMAGE コマンド
Command “CF_IMAGE_%1” [CR]
%1
“STAND” -------------------- Standard mode
“REAL” ---------------------- High contrast mode
“CINEMA”
------------------ Cinema mode
“BLACKBOARD” --------- Blackboard (Green) mode
“CUSTOM1” --------------- Custom mode
Details
Select Image mode. (When it is in usual Power On state, this is valid)
Parameter “CUSTOM1” is the same as selecting ”Custom” on OSD menu
The value set by this Command is stored in EEEPROM, when AC Power Off the
Projector the value will be valid.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.12. CF_IMAGEADJ Command
Command “CF_IMAGEADJ_%1” [CR]
%1
“RST” -------------- Reset Image adjustment
“STR1” ------------ Store current Image adjustment to Custom mode
Details
Reset / Store for Image adjustment.
(When it is in usual Power On state, this is valid)
“STR1” is the same as “Custom” when choosing “Store” on OSD menu.
The setting value set in “Custom” is stored, so even if the Projector is set to AC
Power Off and is turned on again, the setting value will be able to be back.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]