Expanded_Serial_Command_Codes

Expand Serial Command Functional Specification Page 12 of 41
8.4. Image Command
8.4.1. CF_BRIGHT Command
Command “CF”_BRIGHT_%1” [CR]
%1
“000 – 063” ----------- Directly select the Bright setting value
“UP” -------------------- Bright setting value +1
“DN” -------------------- Bright setting value -1
Details
Set the user control Bright value.
The value set by the command will not be saved to the Projector.
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.2. CF_CONT Command
Command “CF_CONT_%1” [CR]
%1
“000 – 063” ------------ Directly select the Contrast setting value
“UP” --------------------- Contrast setting value +1
“DN” --------------------- Contrast setting value -1
Details
Set the user control Contrast value.
The value set by the command will not be saved to the Projector.
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.3. CF_COLOR Command
Command “CF_COLOR_%1” [CR]
%1
“000 – 063” ------------ Directly select the Color setting value
“UP” --------------------- Color setting value +1
“DN” --------------------- Color setting value -1
Details
Set the user control Color value.
The value set by the command will not be saved to the Projector.
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]
8.4.4. CF_TINT Command
Command “CF_TINT_%1” [CR]
%1
“000 – 063” ------------ Directly select the Tint setting value
“UP” --------------------- Tint setting value +1
“DN” --------------------- Tint setting value -1
Details
Set the user control Tint value.
The value set by the command will not be saved to the Projector.
Therefore, when AC Power Off the Projector, the value will return to the original
setting. (For Standby mode, this value stays)
Only valid when it is in the usual Power On state.
Acceptable “000” [CR]
Response
Unacceptable “Error Code” [CR]