User`s guide

1-16
Before You Start
1
Connecting to a Computer
NOTE
• If a Wizard appears after connecting the USB cable by the Plug and Play automatic
setup, install the software for this printer using either one of the following
procedures. For more details, see "Installing the CAPT Software," on p. 3-5.
- Click [Cancel] and install the software from CD-ROM Setup.
- Install with Plug and Play.
• If you are not sure about the USB cable that is supported by the computer you are
using, contact the store where you purchased the computer.
Using a LAN Cable
If the optional network board (NB-C1) is installed, the printer can be connected to
the network using a Category 5 twisted pair cable. Have cables or a hub ready as
needed.
NOTE
• For details on the procedure for installing the network board, see "Network Board," on p.
6-19.
• If this printer is connected to a network, network settings will need to be configured, the
printer will need to be installed as a network printer, the print server will need to be
configured. For details on these settings, see the instruction manual supplied with the
network operating system or "Network Guide".
■ Network Environment
The optional network board supports 10BASE-T/100BASE-TX connections.
• When connecting to a 10BASE-T Ethernet network
LAN Connector
10BASE-T Hub
Computer with
10BASE-T Connector
Computer without
10BASE-T Connector
10BASE-T
Network Board
10BASE-T Cable