User`s guide

22
2
Fan the stack of paper, then tap it on a flat surface to properly
align the edges.
Align the edges of the stack of paper on a flat surface.
IMPORTANT
• When fanning or aligning transparencies, always hold the edges, where possible,
to avoid touching the print side.
• Be sure to load a stack of transparencies after thoroughly fanning them. Otherwise,
they can be fed overlapped, causing paper jams.
• Ta ke care not to mark/stain the print side of transparencies with fingerprints, dust
or oil. This may cause poor printing.
• If the leading edge of the paper is bent or curled, straighten out the paper before
loading it into the tray.
3
Set the paper guide width slightly larger than the paper width.
●
Closing the multi-purpose tray
To close the multi-purpose tray, reverse the procedure for opening the tray.
When you are not using the tray, keep it closed.