User`s guide

2 SafeCom Go Canon
D60707-16 19
Device name and Device model are automatically filled-in. Device location
and Contact person are useful for maintaining the SafeCom solution.
Fill out the Configuration web page according to the following descriptions:
 Login method:
o Auto-sense (default): If a USB ID device is connected to the MFP
then Card or Windows is selected. If no USB ID device is detected
then ID code is selected. The Auto-sense selection changes within
10 seconds after a USB ID device is either connected or
disconnected to the device. Auto-sense is supported in SafeCom Go
Canon S88 010.020*01 and newer.
o ID code: Login by ID code only.
o Card: Login by card only.
o Card or ID code: Login by card or ID code.
o Card or Windows: Login by card or by entering Windows username,
password, and domain.
 Pre-fill domain:
o Blank (default): Use if users belong to different domains. This
means that all users need to enter their domain when they login
with their Windows username and password.
o Default domain: Use if a majority of users belong to a particular
domain as the specified Default domain is pre-filled making it
easier for the users to login with their Windows username,
password, and domain.
o Hide: Use if all users belong to the same domain as it saves users
from being prompted for the domain when they login with their
Windows username and password. Be sure to have specified the
Default domain, otherwise the choice reverts back to Blank when
you click Apply.
Note: The SafeCom G3 server must be a member of the domain or
trusted by the domain.
 Mask ID code: Check to increase security by using the asterisk (*)
character to mask the entered ID code.
 Login without PIN code: Check if users do NOT need to enter a 4-digit
PIN code at login. This setting applies to the device and overrules the
equivalent user property on the SafeCom G3 server.
 Drivers: When Pull Printing, SafeCom compares the driver name
embedded in the print job with this list of driver names. If no match is
found the document appears with a question mark [?] in the document list
on the device. This way the user is warned that fidelity is low and the
document may print incorrectly.
o To populate the list of drivers by retrieving a list of driver names
from the SafeCom server, click Get all and then Apply.
o To add a driver name manually click Add.
o To remove a driver from the list, select the driver name on the list
and click Remove.