User`s guide

2 SafeCom Go Canon
D60707-16 11
2 SafeCom Go Canon
2.1 Overview
Make sure the SafeCom G3 Server software installation has been completed as
described in SafeCom Smart Printing Administrator’s Quick Guide D10600.
1. Install optional card reader (2.2).
2. Prepare MFP for installation (2.3).
3. Install SafeCom Go Canon software (2.4).
Restart the MFP.
4. Specify SafeCom server and register device (2.5).
2.2 Install optional card reader
This section is only relevant if users will login by card. Connect the SafeCom ID
Device directly to the external USB port. The USB port is located at the rear
next to the network port.
Some MFPs feature a USB port near the touch-screen control panel. This is
reserved for connection of storage media, such as USB memory key. Do NOT
connect the SafeCom ID device to this USB port.
2.3 Prepare MFP for installation
For detailed instructions please consult the supplied Canon documentation.
Ensure that the MFP has Department ID management disabled. Please refer to
the appropriate section:
 Canon imageRunner ADVANCE series (2.3.1).
 Older Canon devices (2.3.2).
2.3.1 Canon imageRunner ADVANCE series
Note: When SafeCom is responsible for authentication (SafeCom Go Login is
started) then the Settings/Registration button only works once logged into the
SafeCom solution. Access to Management Settings is only allowed if you are
logged in as Administrator or Technician.
1. Press to access Settings/Registration.
2. Tap Management Settings.
3. Tap User Management.
4. Tap Department ID Management and then Settings.
5. Make sure that Enable Department ID Management is cleared.
6. Tap OK.
Proceed with the installation of the SafeCom Go Canon software (2.4.1).