Technical data
Table Of Contents
- Introduction
- Chapter 1: iRC2100/ 2100S Color Management
- Chapter 2: Simple and Advanced Workflows
- Chapter 3: ColorCalibration
- Chapter 4: ColorWisePro Tools
- Chapter 5: Working with Color in Applications
- Chapter 6: Office Applications
- Chapter 7: Adobe Photoshop
- Chapter 8: PageLayout Applications
- Chapter 9: Illustration Applications
- Appendix A: Desktop Color Primer
- Appendix B: Color Management
- Appendix C: Importing densitometer measurements
- Glossary
- Bibliography
- Index
3
3-5 Using a densitometer
Using a densitometer
ColorWise Pro Tools are designed to work with the X-Rite DTP32 reflection
densitometer where color measurements are entered automatically. When you
cannot obtain an expected result with ReaderCal, use this procedure.
NOTE: Measurements from other densitometers can be input using a simple
ASCII file format (see page C-1).
Setting up the densitometer
Before you calibrate the iR C2100/2100S, you need to connect, configure,
and calibrate the densitometer to prepare for measuring the printed patches
(see “Calibrating the densitometer” on page 3-7). For additional information
about setting up and using the densitometer, see the documentation included
with it.
TO CONNECT THE X-RITE DTP32 TO THE COMPUTER:
1. Turn off the computer.
2. Plug the square end of the interface cable (looks like a modular phone plug)
into the I/O port on the side of the X-Rite DTP32.
Square connecto
r