Specifications

6
Security
6-2 Specifying the System Manager Settings
Specifying the System Manager Settings
You can set an ID and a password for the System Manager. Once the System Manager ID/ password
is set, restrictions can be placed on storing or changing the System Settings.
Remark
Attaching the optional Card Reader-C1 erases the
System Manager ID and System Password that have
been stored.
Depending on the login service being used, if
Department ID Management is set to 'Off' and a
System Manager ID or password is not specified, all
users of the machine may be considered as the
Administrator even without authentication.
If you are performing user authentication using the
SSO-H login service, the System Settings mode is
restricted in the following way:
Users registered as a general user cannot change
the System Settings, regardless of the System
Manager ID setting.
Users registered as an Administrator can change
the System Settings by entering the correct System
Manager ID and System Password or registering
them in their user data in advance.
If the optional Card Reader-C1 is attached, the
numbers 1 to 1,000 cannot be used for the System
Manager ID. Numbers 1 to 1,000 are reserved for
control cards by default.
For instructions on entering characters, see "Basic
Operations(p.3-1)."
The maximum number of digits that you can store for
the System Manager ID and System Password is
seven. If you enter fewer than seven digits for either
setting, the machine stores them with leading zeros.
- Example: If <321> is entered, <0000321> is stored.
1. Press → [System Settings] → [System Manager Settings].
Acesst 1.0 6251194