Specifications

5
Additional Functions
5-74 Setting an Output Tray to Hold Different Paper Sizes
Setting an Output Tray to Hold Different Paper Sizes
This mode enables you to output different paper sizes to the same output tray.
Remark
This mode is available only if an optional finisher is
attached.
1. Press → [Common Settings] → [Different Paper Sizes for the Output
Tray].
2. Select [On] or [Off] → press [OK].
If Different Paper Sizes for the Output Tray is set to 'Off', and the message <Remove the
paper from the output tray.> is displayed, printing stops. Remove all of the paper from the
output tray, and printing resumes.
If both the Different Size Originals and Staple modes are set, outputs are stapled and
collated, regardless of the Different Paper Sizes settings.
Even if you set Different Paper Sizes for the Output Tray to 'Off', different paper sizes are output to the
same output tray in the same way as when Different Paper Sizes for the Output Tray is set to 'On' when
outputting to the Copy Tray-J1 or Buffer Pass Unit-E2.
Even if you set Different Paper Sizes for the Output Tray to 'Off', different paper size may be output to the
same output tray if there is only a small amount of paper in the paper tray.
Acesst 1.0 6251194