Specifications

5
Additional Functions
5-42 Energy Consumption in the Sleep Mode
Network
Settings
TCP/IP Settings
NetWare Settings
AppleTalk Settings
SMB Settings
E-Mail/I-Fax
DHCP is set to 'On'.
NetWare is set to 'On'.
AppleTalk is set to 'On'.
SMB is set to 'On'.
The POP Interval setting is set to less than '10' minutes
(except when the POP Interval setting is set to '0').
*1
If there is more than 10 minutes remaining before the specified time, the machine consumes the
same amount of energy as when the energy consumption level is set to 'Low'.
1. Press → [Common Settings] → [Energy Consumption in Sleep Mode].
2. Select [Low] or [High] → press [OK].
Details of each item are shown below.
[Low]: Energy consumption in the
Sleep mode is low, but it takes
longer to recover from the
Sleep mode.
[High]: Energy consumption in the
Sleep mode is high, but it
takes shorter to recover from
the Sleep mode.
If Energy Consumption in Sleep Mode is set to 'Low', it may take more than 10 seconds for the touch panel
to be displayed after pressing the control panel power switch.
Acesst 1.0 6251194