Specifications

4
Optional Equipment
4-44 Finishing Modes
Remark
If a finisher is
attached to the
machine, do not
place your hand in
the part of the tray
where stapling is
performed or where
the rollers are
located, as this may
result in personal
injury.
If the Staple mode is set, the output trays move
downward as the stack of paper that is output
increases in quantity and thickness. Once an output
tray has reached its stacking limit, or after 30 sets of
prints have been output, printing and stapling stop
temporarily. Remove all of the stapled prints from the
output tray, and printing and stapling resume.
You cannot corner or double staple A5R paper.
You cannot staple transparencies, envelopes, tracing
paper, or labels.
Do not pull copies or prints out of the output area while
they are being stapled. Remove the copies or prints
after they are output to one of the output trays.
The maximum number of sheets, including cover
sheets, that can be stapled together is 30 sheets of A3
or A4R paper, and 50 sheets of A4 paper.
If the machine stops while stapling and the message
<Load staples.> appears, almost all of the staples
have been used, and the staple cartridge must be
replaced. To proceed, replace the staple cartridge.
Saddle Stitch Mode
The Saddle Stitch mode enables you to make booklets, consisting of pages folded and stapled in the
centre.
Acesst 1.0 6251194