Specifications

4
Optional Equipment
Finishing Modes 4-37
Remark
Do not place your
hands in the part of
the tray where
stapling is performed
(near the rollers)
when a finisher is
attached, as this
may result in
personal injury.
Do not place objects
or lean against the
finisher unit when it
is extended. Doing
so may damage the
finisher or cause the
machine to tip over,
resulting in personal
injury.
Do not place your
hands into the open
spaces around the
moving finisher
trays. Doing so may
result in personal
injury or damage to
the finisher.
Do not place
anything under the
trays of the finisher,
as doing so may
damage the trays.
If the Staple mode is set, the output tray moves
downward as the stack of paper that is output
increases in quantity and thickness. Once the output
tray has reached its stacking limit, or after 30 sets of
prints have been output, printing and stapling stop
temporarily. Remove all of the stapled prints from the
output tray, and printing and stapling resume.
Only the following paper sizes can be stapled: A3, A4,
or A4R.
You cannot staple envelopes, transparencies, tracing
paper, or labels.
The maximum number of sheets, including cover
sheets, that can be stapled together is 30 sheets of A3
or A4R paper, and 50 sheets of A4 paper.
If the machine stops while stapling and the message
<Load staples.> appears, almost all of the staples
have been used, and the staple cartridge must be
replaced. To proceed, replace the staple cartridge.
Hole Punch Mode
The Hole Punch mode punches two or three holes (depending on the paper size) in the printed
sheets.
Acesst 1.0 6251194