Service manual

Chapter 2
2-23
F-2-66
15) Connect the connector of the repeating harness B [1] to the connector J317 [2] on the image processor PCB.
F-2-67
16) Using the supplied binding screw (M4x6) [1], secure the repeating harness B clamp [2].
F-2-68
17) Using the three harness covers (lids) [2], secure the repeating harness B [1] to the harness covers (bases).
F-2-69
18) Using a nipper, remove the precut portion [1] of the rear cover as shown below.
[1]
[2]
[1]
[1][2]
[1]
[2]